NANPU 3/8" NPT Compressed Air Filter Regulator Lubricator Combo Water/Oil Trap Separator - Gauge(0-150 psi), Poly Bowl, Semi-Auto Drain, Bracket - 3 in 1 Two Unit

Fast delivery,easy installation and working as expected.

Works as it should. Seems to be good quality. Been using for over a year with no problems.

The motor on my old air com pressor went bad so I bought a new one .. I tried to hook up my old air gage to it but it started leaking air so I bought this one to replace it . I hook it up and the works fine but sometimes during the night it leaks a little air .. Not enough to be concerned with so I'm ok with it for now . I did check all my air stations and found no leaks so It must be some where in the air filter regulator . It does not leak all the time but it does sometime according to the gages .

Exactly what I needed fit good. Good price and delivery as expected

Complete kit and well made

The machined 1/4 nipples that come with it were a little too loose in the thread housing of the regulator so I used A LOT of Teflon tape to get them snug. Also the Teflon tape that comes with it is cheap. I used store bought Teflon tape. Once hooked up I decided to press in the manual drain at the bottom of the water filter cup to drain the water (while the regulator was under a load. BIG MISTAKE, the o ring that seals the drain got bound up in a hole on the moisture drain plug and was then leaking while in the closed position(the purpose of the horizontally drilled hole in the drain plug I'm not to sure). I had to disassemble the water trap remove the C clip holding the drain plug pin in place and very carefully use a pick to fish the O-ring out of the hole in the pin. It was a pain in the butt because the parts are so small. Doesn't do a good enough job filtering water either. I'm constantly blowing out water mist from my tools. Also the housing of the oiler bottle has a leak because the outside of the oiler is always, well... oily. Water gets in my oiler as well defeating it purpose. With the oiler turned on it doesn't distribute oil to my tools it just puddles up in the coupler coming off the oiler. This may be because I have high-flow couplers and high-flow male plug fittings instead of your normal fittings, I don't know. Also the pressure gauge is not accurate. I had my suspicions so I attached a high end glycerin filled gauge to the end of my air hose past the regulator. I set the regulator to 90 my pressure reading on the gauge at the end of the hose was nearly 100psi. To be sure I also hooked up a secondary regulator past this regulator and opened it all the way while setting the purchased regulator at 90 psi, same reading on the fully opened regulator past this one at nearly 100 psi. Also the increments on the pressure gauge don't make sense. Instead of normal 5 or 10 psi markers on the gauge this one goes in increments of like 7 or something close to that, which is weird. But hey you get what you pay for right?

This a nice product in theory but fails miserably in functionality. The mounting bracket on the one I received was completely useless as it was not made correctly. I ended up only using the dryer as I didn't want oil in my air hose.

I ordered this with great intentions but didn't get around to installing until well past the warranty. When I finally did get it hooked up to air, there was a gasket leak at the oiler. I contacted the company hoping to purchase a replacement gasket. They responded almost immediately asking for a photo of the defective part. I sent it and they shipped out a replacement that same day. When the part arrived, my problem was solved, and they didn't charge me a thing.Wonderful to deal with!!